Systea S.p.A.

Analytical Technologies

希思迪-应用软件

Fusion software was specially created for Windows XP/7/8/10 and it was xompletely written and full supported by SYSTEA.

Setting up a run is easy, the user simply clicks the work list icon or menu and selects colored symbols for each type of standard, QC, or sample.

The operator, then chooses which analysis will be performed on the work list, by selecting a pre-defined method. Multiple methods can be selected for each sample, standard, or QC. Pre-run dilutions can be selected on specific samples, and standards can be automatically prepared from a stock solution. Automatic dilution and rerun of off-scale samples can also be selected.

QC Controls

Up to five levels of real time QC’s can be used. QC results are automatically stored and plotted in a user defined QC chart. In case of QC failure, the analyzer can stop the run or simply notify the operator, flag the QC result, and go on. After the run, EasyChem software shows the limits for the QC standards and prints a symbol to show at a glance whether each passed or failed.

LIMS Connection

Data can be transferred to an internal or network drive at the end of the run (in a Text or ASCI format). Sample IDs can be imported from a central computer. Fusion software is compatible with all windows supported networks.


实验室分析仪管理软件

EASYCHEM应用软件

EasyChem应用软件适用于Windows XP及以上系统,由SYSTEA全权开发支持。

用户仅需点击工作列表图表或者在菜单中选取由不同颜色表示的标样、质控以及样品选项,即可进行进一步操作。

用户随后可在工作列表中选择对应的分析方法,每个样品、质控或标样均可复选多个分析方法。软件还可选定指定样品进行预稀释,标准液可由浓缩液直接通过稀释后制得。用户还可以通过软件设置超量程样品自动稀释再分析测量。

质控管理

最多可使用5级实时质控,质控结果自动存储并可根据用户自定义绘制质控图表。一旦质控量超限,分析仪会停止分析或者通知操作员标记超限质控量后继续测量。分析测量完毕后,软件会显示质控的标准限度并以符号标示每组测量是否符合质控要求。

连接限制

数据在分析完成后会被传送至内部或网络驱动 (文本或ASCII格式);样品号可通过中央计算机导入; EasyChem的软件可与任何Windows支持的网络服务相兼容。